Skip to content
EvaForm

Thermoformed EVA Foam: Large Shallow 3D Shapes

Thermoforming heats an EVA foam sheet until it softens and draws it over a form tool with vacuum or pressure. It is the right process for large, shallow 3D shapes — liners, trays, housings and panels — where a matched molding tool would be too expensive.

Process limits

Thermoforming guidelines
ParameterTypical limit
Sheet thickness2–12 mm
Draw depthUp to about 2.5× the sheet width for EVA
Draft angleMinimum 3° (5° preferred)
Corner radius≥ 3 mm
Thickness uniformityVaries with draw; minimum thickness should be specified
Tolerance±0.8 mm
ToolingSingle form tool (male or female), lower cost than a matched mold

Where thermoforming is used

  • Equipment and vehicle interior liners.
  • Case and trunk lid and base shells.
  • Large trays and housings for industrial equipment.
  • Point-of-purchase and retail display forms.
  • Insulation covers and equipment housings.
Start a project

Get a quote and a sample for your project

Send us the dimensions, a drawing or the physical part. You will get a written DFM review, a unit price and a sample plan within 12 business hours.

Or email sales@eva-form.com · MOQ from 1 piece · sample in 5–7 days · mass production 15–25 days

Frequently asked questions

Can you heat form EVA foam?
Yes, EVA softens and can be formed over a mandrel or a form tool.
What is the difference between thermoforming and molding?
Thermoforming draws a heated sheet over a single tool, so it suits large shallow shapes. Molding uses a matched cavity and core, so it suits closed 3D shapes and deeper draws.
Will the part be thinner than the sheet?
Yes — the sheet stretches, so specify a minimum wall thickness in the deepest draw.
What is the economic volume?
Any quantity from one piece. A form tool is required, so unit cost improves at larger volumes.

Buyer specification checklist

What should I specify for the insert?

The core inputs are product size, weight, cavity depth, density, thickness and tolerance. EvaForm uses these six values to select the EVA grade and cutting route.

Which conversion process fits my part?

Die cutting is the most economical route for high-volume flat inserts. CNC routing suits multi-level cavities; molding fits deep 3D shapes.

What happens after I send a drawing?

You receive a DFM note, price and sample plan within one business day. Include quantity, colour or finish, destination port and target date.

Which standards guide the material choices?

EVA foam packaging is normally specified against ISO 9001 quality control, RoHS/REACH material compliance and UL 94 flammability classifications. These references help buyers compare suppliers on evidence rather than claims.

“Specify density, hardness and tolerance before discussing price; the rest is process selection.” — EvaForm Engineering Checklist